Condor Classic series
Use your existing work holders on the Condor Sigma
The most ergonomic bondtester on the market
Patented self aligning shear tool up to
500 kgf
1 to 6
cartridges
up to
200 kgf
Full control at your finger tips
Monitor can be stowed for easy transportation
Quick release mount: change work holders in seconds
Condor 150HF goes up to
500 kgf
Full debris control with Condor Sigma
- ball shear / solder ball shear
- bending
- cavity shear
- cold bump pull
- die shear
- fatigue
- high speed impact
- lead integrity
- lid torque
- overhanging die
- passivation layer gold ball shear
- ribbon peel
- ribbon pull
- stud pull
- total ball shear / zone shear
- tweezer pull
- vector pull
- wedge and ribbon shear
- wire pull
Lid torque test: place your sample in the customized sample holder
Lid torque
- Retrofit module
- Flexible testing
- Complies with MIL-STD-883 METHOD 2024
- Customized sample holders for your samples
- Unique solution, nowhere else available
Lid torque testing for glass-frit-sealed packages
The purpose of this test is to determine the shear strength of the seal of glass-frit-sealed microelectronic packages. This is a destructive test.
Failed sample after lid torque test
The device is held by the device body and torque applied to the lid of the device or vice versa. The lid torque fixtures is designed to assure that it only applies torque to the side area of the package lid, base, or spacer.
Contact to the sealing glass is therefore avoided. For ease of use and to avoid interference, the package leads are removed prior to test. The torque is applied gradually and smoothly until package separation occurs, or the reaching of the 12.8 newton meter torque limit. The torque required for package separation or the reaching of the 12.8 newton meter torque limit is recorded. The torque is applied such that the axis of rotation is perpendicular to the sealing plane and the axis of rotation is located at the geometric center of the sealing area.
A device where package separation or breakage occurs at a torque value less than specified is a failure.
Video showing sample being tested
Contact us
Did we catch your attention? Please contact us for more information, to request a demonstration or a quotation.
Special applications
Please contact us if you have any questions or special ball shear requirements.