Stud pull with self aligning plate

Stud pull

High strength adhesive experience for the most challenging die pull applications
Self aligning studs to prevent die peel
Sensor accuracy ±0.1% of range
Test at elevated temperatures up to 500°C

Stud pull for exotic applications

Stud pull test on key pad

Alternative test for thin die attach

The stud pull test is used to test bonded dies or pins pressed in FR4 boards. For die attach, the sample is clamped in a work holder and a stud is glued on the part to be tested. The stud is then pulled by a tweezer or other specially designed tooling. Depending on the stud pull application, XYZTEC can offer solutions from a few grams up to 500kgf. We also offer a manual tweezer that can test up to 40kgf and an optional camera system is available to record and analyze failure mode.