芯片推力

Die shear on LTCC
LTCC推力测试

各式芯片测试应用的技术领导者

推力值可以非常具有代表意义,依据不同类型的连结层(焊锡,导电胶, 非导电胶) 以及芯片尺寸.

为了涵盖这个范围, XYZTEC 提供一个广泛的工具选择和夹具. 除此之外, 也可以提供客制化的工具. 我们的Condor 150HF 可以执行高达500kgf 的推力.


专利设计的自动对位推刀

There are three aspects of these designs that make testing difficult. Firstly, the reduced ratio of die thickness to die bond area, shown in this illustration. Secondly, die and substrate warpage can be a problem. And thirdly, the bond strength is often very high, for example when silicon is bonded directly to silicon or other similar materials.
There are three aspects of these designs that make testing difficult. Firstly, the reduced ratio of die thickness to die bond area, shown in this illustration. Secondly, die and substrate warpage can be a problem. And thirdly, the bond strength is often very high, for example when silicon is bonded directly to silicon or other similar materials.
The self aligning shear tool is designed for forces up to 500kgf
The self aligning shear tool is designed for forces up to 500kgf

A fundamental problem exists when shear testing large die; the strength of the bond is in proportion to the area of the die but the area available to apply the shear load is much smaller being limited to that of one of its edges. As die become larger and thinner the relative sizes of these two areas can result in the stresses created by the shear tool being higher than the yield strength of the die causing it to splinter or shatter before the bond is tested.

In many cases this undesirable effect can be eliminated with the use of XYZTEC’s latest shear tool development*. The part of the tool that contacts the die is a shear block. It should be a relatively soft material like aluminium or mild steel. Because it is softer than the die it deforms at the points of contact that inevitably result due to surface irregularities between the edge of the die and the tool tip. This deformation considerably reduces the high contact stresses that would otherwise cause the die to fail.

XYZTEC discovered that it os often better to use a shear tool made of a relatively soft material when performing high force die shear
XYZTEC discovered that it os often better to use a shear tool made of a relatively soft material when performing high force die shear
Self aligning shear tool
Side view self aligning shear tool

The shear block is held in place on a mount by vacuum. The block can rotate slightly (self alignement). Another feature is that its underside can include an undercut that ensures a precise shear height. Without this system deformations in the vertical axis caused by the very high shear forces can cause the shear tool either rise or fall relative to the substrate. If the tool lifts it increases the stress concentration on the edge of the die making die failure likely. This feature is ideally suited for testing stacked die which are very thin and require such precise control of shear height. XYZTEC offers a complete solution for die shear testing that consists of the self aligning tool and a special die shear work holder. This combinations supports high shear forces. The work holder also offers a protection cap for the safety of the operator and with specials masks it is possible to test dies on different angles and in different sizes.

* Patent PCT/NL2010/050545, CN102770747, EP2473832, WO2011028107

Click here to download the flyer on our "Self Aligning Shear Solution" (PDF).


Contact us

Did we catch your attention? Please contact us for more information, to request a demonstration or a quotation.


© 1999-2016 XYZTEC BV Disclaimer, Privacy, Cookies
Technology leader in bond testing worldwide